UVR-1/USC-1 Control Enclosure

Powder Coated Steel, Part #11000

Enclosure is available in either 16-gauge powder coated mild steel or stainless steel and is suitable for mounting onto either the existing regulator or directly on a wood pole.
Enclosure is approximately 22”H x 12”W x 10”D - weighs approximately 20 pounds (without controls).
Enclosure supplied with a dual pad-lockable hinged door with MIL Spec grade gasketing. All external hardware is stainless steel.
One 1.125” hole is drilled on the top left of the enclosure for cable connection to the voltage regulator and a water-tight hub for 5/8” control cable is supplied. Two .875/ 1.125” knockouts are located on the bottom of the enclosure in addition to dual screened ventilation holes.
Enclosure is supplied with an external grounding stud as well as dual universal mounting flanges.
Internal “L” bracket on the left side of the enclosure together with hinges on the right side used for the installation of either the UVR-1, USC-1, or UVR-1 LTC controller.
There is a stud for mounting an external motor capacitor inside the enclosure as well as studs to mount individual back plates with connections for either GE, Siemens, or Cooper control cables. A universal back plate (Part #11210) with a wiring strip that will connect to all (GE, Siemens, and Cooper) control cables is also available.